#Kitchen space saver provo full#

Typical installation is a screw every 16 inches. Continue to unscrew each cabinet unit wherever it is attached to the wall. Unscrew the screws from the cabinets back.Don’t skip this step, as pulling the cabinets or countertop away from the wall could damage the wall if not cut through with the utility knife. Use a utility knife to cut through any caulking between the sides and bottom of the cabinets where they meet a wall.Insert several of the cut boards into the gap to support the upper cabinets.Place these boards at each corner and in the middle of the cabinet span. Cut scrap wood 2x4s to fit the gap between the bottom of the upper kitchen cabinets and the countertop.Cover the countertop with a blanket or furniture pad.If the cabinets have cove molding along the soffit, remove that with a small pry bar.Label the back of them if you are planning on reusing your cabinets. Tape the screws to the door near the hinge. Remove doors by unscrewing the hinge screws on the cabinet’s side, leaving the hinge attached to the door.This step is best done with an assistant to provide additional support to the upper cabinets as you unscrew them. You should start with the uppers so that you can use the kitchen counter as a support while you unscrew the upper kitchen cabinets. Remove the upper cabinets in your kitchen first. Rent a dumpster and have it scheduled for delivery to your home before you start demo work.Remove the range hood or the over-the-range microwave.Remove any small fixtures, such as a paper towel holder, a spice rack, or under-counter inset lights from your cabinets.

Lay protective covers over your floor to protect it.

Remove toe-kicks and any molding around the wall and base cabinets.

Remove the appliances from your kitchen.

Shut off your gas line using an adjustable wrench if you have a gas oven/stove.

Turn the electricity to the kitchen off at the breaker box.

Disconnect the electricity, especially if you have a garbage disposal, built-in dishwasher, electric stove, and outlets in the backsplash.

You don’t have to shut off the whole house water supply, but be sure the line to the kitchen sink, your dishwasher, and your refrigerator’s ice maker are off. Step 1: Prep Your Kitchen for Cabinet Removal If you want to keep or donate them, you will need to take care during the removal process to not damage them.Ĭontinue reading our blog on removing kitchen cabinets. You can save your cabinets to refinish them, reuse them in another part of your home like a laundry room or garage, or you can donate them if they are in good condition. This frees up more money in your budget to spend on the rest of your kitchen remodel.īefore starting the tear-out, decide on whether you want to save your cabinets or not. Kitchen cabinet and countertop demo can cost from $150 to $600, depending on the size of the kitchen, with very large kitchens running closer to $1,000. When we were designing our kitchen remodel, we realized that taking out the cabinets ourselves would save us a lot of money, hundreds of dollars in fact. Taking down all your kitchen cabinetry can seem like a daunting project, but it is doable by the average homeowner DIY enthusiast. Even if you are looking to just revitalize your existing cabinets and not replace them completely, it is easier and results in a better end product if you completely remove your cabinets from the walls before painting or refinishing them.

#Kitchen space saver provo full#

Changing out your kitchen cabinets, whether as part of a full kitchen demolition, kitchen remodel, or just a cabinet update, can improve the look of your whole kitchen.